Flange-Mount Ventilation Blower
High-Output DC Blower - 1000 Hour Motor Life
This DC blower for high-volume air intake or extraction are designed for engine rooms or fuel compartments. It also works well for galleys, bilges, accommodation and head compartments.
The flange-mount blower is of a radial design that produces the highest output in more complex installations with longer ducting lengths and/or multiple bends in the ducting. They are generally mounted directly onto a flat bulkhead using a mounting collar to connect to the discharge ducting. This allows a very neat installation on an engine room bulkhead.
Jabsco DC blowers are designed to remove fumes from the engine compartments of gasoline-powered boats prior to start-up and therefore conform to ISO 8846 MARINE and USCG Regulations for ignition protection. Note: AC models are NOT ignition protected.
Features:
- Outlet flange mounts directly on bulkhead
- Tough reinforced-plastic housing
- Mounts to any surface
- Slip-On inlet and outlet ducting connection
- Efficient high-volume air flow
- Low current draw
- Dimensionally stable, quiet-running Delrin(R) rotors
- Corrosion-resistant material construction
- N.M.M.A. type accepted
- Meets USCG Regulation 183.410
- Complies with ISO 8846 MARINE for Ignition Protection
- Complies with ISO 9097 MARINE for Electric Fans
- Conforms with EN 50081-1 for Suppression of Electromagnetic
Interference
- CE approved
Mfg No. 34739-0010
Duct Size 3" (75mm)
Maximum Output 150 CFM* (4.2m3/min)
ISO 11105 Rated Compartment Size 75-90 Cubic Ft (2 - 2.5m3)
Dimensions (Length x Width x Height) 8" x 6-3/4" x 7-3/4" (19.5 x 17 x 20mm)
Voltage / Fuse Size 12 VDC 10 Amp
* CFM - Cubic Feet per Minute
Note: This standard-duty Jabsco blower is primarily intended for intermittent-duty cycles, such as evacuating fuel vapors from bilge areas - 15 minutes maximum. If desired, they also may be used for other general air circulation applications with longer duty cycles. However, when doing so, it should be noted that the maximum motor life is approximately 1000 hours. Therefore, the blower should only be used for applications if this length of service is acceptable.
Only the heavy-duty blowers are designed for continuous-duty operation in commercial or heavy-use applications.
Note also: Blowers should not be installed close to sources of direct heat exceeding 180° F (55° C).
-
MSRP
-
$244.38
-
U/M
-
/ EA
-
Price
-
$207.72
-
Core
-
-
Part Number
-
34739-0010
-
Manufacturer
-
Website Jabsco
-
Brand
-
-
ETA
-
-
Quantity Available
-
2
-
Quantity On Order
-
